A personal detailed view of a journey of acquiring IT certifications and career progression.
Tuesday, June 28, 2011
RIPv1Characteristics
I went over the beginning pages in the Vol I book regarding the RIP version 1 protocol. There are some interesting things that should be noted about version 1 compared to version 2. I'll list what I remember:
1. Version 1 is a classful protocol rather than a classless protocol.
2. Since it's classful RIPv1 can become problematic when running the protocol over a discontiguous network.
3.RIPv1 pass the entire network class that it knows about when advertising routes rather than the specific subnet unless the subnet is directly connected. Again this points back to numero uno.
4. The only subnets it will list in the routing table are the subnets that's directly connected to the router.
5. RIPv1 assume any subnets that it knows about will be the same subnet size throughout the entire network. Variable subnetted networks could easily cause a lot of problems.
Sunday, June 26, 2011
Finishing up TCP/IP Vol I Chapter 4
I went ahead and tackled the rest of chapter 4 regarding dynamic routing protocols. Tomorrow I'll knock out the review questions and then it's time for part II of the book. Which is the meat and potatoes of what the book is about and I should have a lot more lab design, configuration, and troubleshooting which is what I need right now.
Saturday, June 25, 2011
TCP/IP Vol I Chapter 4 - Dynamic Routing Protocol Overview
I read through about 20 pages this morning regarding dynamic routing protocols and the basics of why and when they're used. Brushed up a little on my Split-Horizon understanding and how distance vector works. I know I know, it's kindergarten stuff I believe you need to have a thorough understanding of the fundamentals if you want to even think about going after the CCNP certs let alone the big bad CCIE. I plan on knocking 10-20 more pages out tomorrow and to have the chapter finished by next weekend depending on how much time I can spare.
Once I finish the TCP/IP book I'm going to begin drawing out my CCNP:Voice lab requirements and prepare myself to get ready to spend some $$$. I also plan on moving in August and hopefully adding a few simple mods to my car (I drive a Subaru WRX STI) so I probably won't be saving much over the next 3-6 months!
Once I finish the TCP/IP book I'm going to begin drawing out my CCNP:Voice lab requirements and prepare myself to get ready to spend some $$$. I also plan on moving in August and hopefully adding a few simple mods to my car (I drive a Subaru WRX STI) so I probably won't be saving much over the next 3-6 months!
Thursday, June 23, 2011
TCP/IP Vol I Troubleshooting Exercises Chapter 3
This evening I briefly ran through some of the static route configuration exercises. I've been swamped at work lately, working 10-12 hour days seems to be the norm lately. I'm not progressing through this book as fast as I like because of being drained by the time I get home. We will be opening a new remote site soon so I'll be even busier, not to mention we're still knocking out the kinks from upgrading our entire Cisco phone system from version 6/7 to 8.5. There's a weird call transfer issue going on when internal users transfers a caller to another user through UCCX.
Basically a caller will call Internal User A, Internal User A will then put the caller on hold, dial a different UCCX CSQ Trigger (CTI Route Point) which then goes through a queue and then to Internal User B via a random CTI Port. Internal User A then attempts to transfer Internal User B but from the reports I receive about 85% of the time Internal User B receives a fast busy when Internal User A hits the transfer button on their phone. Any suggestions lol?
Quick Tip of the day, For those who have the same amount of trouble as me with stack switches booting in the right order. The easiest way is to boot the first switch you want as master completely, then connect the stack cable to the switch(switches) you want to be clients and power them on. Make sure that IOS MATCHES otherwise you'll more than likely run into version mismatch errors like no tomorrow.
Monday, June 20, 2011
TCP/IP Vol I Config Exercises 3-14
I ran through the second configuration exercise in the TCP/IP Vol I book on chapter 3 this evening. For this lab there was a requirement to configure static routes on all routers with redundancy between each routers next-hop router. At first I thought that a floating static route would solve the issue but what I forgot is that none of the other routers would have a clue if a link went down since there wasn't a dynamic routing protocol involved. I simply took the floating static route out along with the AD (Administrative Distance) and added it back in without the AD. Now each router had a redundant route to each far end network and was load balanced using IP CEF. This solved my issue for the most part but I bet there are some ways that the packet can still not route correctly but I haven't dove to deep in all the possibilities.
The above picture shows router RTD with a path to RTB's far end network 172.16.7.0 /24 going through either RTA or RTC. RTA link is down due to a fiber cut so RTD took the route out of it's RIB and forwarded it towards RTC instead.
Sunday, June 19, 2011
TCP/IP Vol I Config Exercises 3-13
I spent about 2-3 hours this morning answering review questions for the TCP/IP Vol 1 Chapter 3 section regarding static routes. For now I'm skipping most of the IPv6 stuff, I'll circle around to it a little bit later during my CCNP: Voice studies. I finished off today's studying session by completing the 3-13 Configuration Exercise. This lab involved 6 routers, a bunch of discontiguous networks, and some summarized IP network configuration requirements thrown in for fun. Everything went pretty good, I'm starting to get in the groove again finally of setting up networks in GNS3.
Sunday, June 12, 2011
Certification Path and TCP/IP Vol I
I decided not to go and test for the CCNA: Security at this point in time. I believe at this point there's really no need but I did cover all of the material and took what I've learned and applied as much as I could in my current job role. Most likely I'm going to take a hiatus from taking any actual tests and prepare to go straight for the CCNP: Voice in about 9-12 months since that's the field I'm in and I already have a really good start.
That doesn't mean I'm not going to study at all though. On the weekends I spend about 1-3 hours going through the CCIE TCP/IP Vol I book, I need to have IP Fundamentals understood as much as possible. Today I labbed up a simple four router network using nothing but static routes. I've learned that specifying an exit interface (i.e. FastEthernet 0/0) rather than the next-hop router IP address with static routing could generate excessive traffic on a broadcast network. The router uses ARP to query were the packet should be sent rather than just using the next-hop IP address defined in the static route. Below is to example static route configs along with the picture of the lab I worked on:
ip route 10.1.0.0 255.255.0.0 192.168.1.66 (Next-Hop IP Address, preferred method)
ip route 10.1.0.0 255.255.0.0 FastEthernet0/0 (Uses ARP/Broadcast, can be CPU Intensive)
That doesn't mean I'm not going to study at all though. On the weekends I spend about 1-3 hours going through the CCIE TCP/IP Vol I book, I need to have IP Fundamentals understood as much as possible. Today I labbed up a simple four router network using nothing but static routes. I've learned that specifying an exit interface (i.e. FastEthernet 0/0) rather than the next-hop router IP address with static routing could generate excessive traffic on a broadcast network. The router uses ARP to query were the packet should be sent rather than just using the next-hop IP address defined in the static route. Below is to example static route configs along with the picture of the lab I worked on:
ip route 10.1.0.0 255.255.0.0 192.168.1.66 (Next-Hop IP Address, preferred method)
ip route 10.1.0.0 255.255.0.0 FastEthernet0/0 (Uses ARP/Broadcast, can be CPU Intensive)
Subscribe to:
Posts (Atom)